|
Mubychem Group, is a mature manufacturing company since generations. Engaged in manufacture and supply of Pharmaceutical Intermediates and Excipients, Oil field & fracturing chemicals, Specialty tailor made grades of chemicals in India. With several manufacturing facilities in India and world wide contacts and toll manufacturers we are exporting to all the countries in the world.. |
The company and associated units have certificates & accreditations like FDA - GMP approval; ISO-9001 Certified; "REACH" Registered; ISO-22000; Kosher Certified; Halal Certified; HACCP. We offer Commercial Pure & Pharmacopoeia IP BP USP FCC Food Grade ACS AR Analytical Reagent Grades of Chemicals |
|
--------
Soda Lime Manufacturers, SDS MSDS Sheet
Soda Lime USP BP IP ACS Analytical Reagent FCC Food grade Manufacturers
Soda Lime SDS MSDS Sheet, Material Safety Data Sheet
1. Product Identification
Synonyms: None
CAS No.: Not applicable to mixtures
Molecular Weight: Not applicable to mixtures
Chemical Formula: Not applicable to mixtures
2. Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Skin corrosion/irritation Category (H315)
Serious eye damage/eye irritation Category 1 (H318)
Acute toxicity, inhalation Category 4 (H332)
Specific target organ toxicity - single exposure, respiratory (Category 3) (H335)
Hazardous to the aquatic environment, acute hazard Category 3 (H402)
Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements  Corrosive |
Signal Words: Danger
Hazard Statements:
H315: Causes skin irritation.
H318: Causes serious eye damage.
H332: Harmful if inhaled.
H335: May cause respiratory irritation.
H402: Harmful to aquatic life.
Precautionary Statements: P304+P340, P312
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P264: Wash … thoroughly after handling.
P262: Do not get in eyes, on skin, or on clothing.
P271: Use only outdoors or in a well-ventilated area.
P273: Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P360: Rinse immediately contaminated clothing and skin with plenty of water before removing clothes.
P362: Take off contaminated clothing and wash before reuse.
P302+352: IF ON SKIN: Wash with soap and water.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. P305+351+338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing.
P314: Get Medical advice/attention if you feel unwell.
P332+313: If skin irritation occurs: Get medical advice/attention.
P337+P313 If eye irritation persists: Get medical advice/ attention.
P501: Dispose of contents/ container to an approved waste disposal plant.
Classification according to EU Directives 67/548/EEC or 1999/45/EC:
Xi: Irritant.
R37/38: Irritating to respiratory system and skin.
R41: Risk of serious damage to eyes.
3. Composition/Information on Ingredients
Ingredients:
Item1: Sodium Hydroxide
CAS Number: 1310-73-2
Percent: < 2%
Item2: Potassium Hydroxide
CAS Number: 1310-58-3
Percent: < 3%
Item3: Calcium Hydroxide
CAS Number: 1305-62-0
Percent: > 80%
4. First Aid Measures
Always seek medical attention after first aid measures are provided.
Inhalation: If inhaled, remove to fresh air. If breathing is difficult, give oxygen. Get medical attention immediately.
Ingestion: Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. If large quantities of this material are swallowed, call a physician immediately. Loosen tight clothing.
Skin Contact: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention immediately. Wash clothing before reuse. Thoroughly clean shoes before reuse.
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes, lifting lower and upper eyelids occasionally. Get medical attention immediately.
5. Fire Fighting Measures
Fire: Not considered to be a fire hazard.
Fire Extinguishing Media: Use extinguishing media appropriate for surrounding fire.
Special Information: Solution process causes formation of corrosive fumes. In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face-piece operated in the pressure demand or other positive pressure mode.
6. Accidental Release Measures
Small Spill: Use appropriate tools to put the spilled solid in a convenient waste disposal container. If necessary: Neutralize the residue with a dilute solution of acetic acid. Finish cleaning by spreading water on the contaminated surface and dispose of according to local and regional authority requirements.
Large Spill: Corrosive solid. Stop leak if without risk. Do not get water inside container. Do not touch spilled material. Use water spray to reduce vapors. Prevent entry into sewers, basements or confined areas; dike if needed. Call for assistance on disposal. Neutralize the residue with a dilute solution of acetic acid. Finish cleaning by spreading water on the contaminated surface and allow to evacuate through the sanitary system.
7. Handling and Storage
Keep in a tightly closed container, stored in a cool, dry, ventilated area. Protect against physical damage. Isolate from incompatible substances. Containers may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product.
8. Exposure Controls/Personal Protection
Airborne Exposure Limits:
-OSHA Permissible Exposure Limit (PEL):
Calcium Hydroxide: 15 mg/m3 (total dust), 5 mg/m3 (respirable fraction), (TWA);
Sodium Hydroxide: 2 mg/m3 (Ceiling)
-ACGIH Threshold Limit Value (TLV):
Calcium Hydroxide: 5 mg/m3 (TWA);
Sodium Hydroxide: 2 mg/m3 (Ceiling);
Potassium Hydroxide: 2 mg/m3 (Ceiling)
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures below the Airborne Exposure Limits. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area.
Personal Respirators (NIOSH Approved): If the exposure limit is exceeded and engineering controls are not feasible, a full face piece particulate respirator (NIOSH type N100 filters) may be worn for up to 50 times the exposure limit or the maximum use concentration specified by the appropriate regulatory agency or respirator supplier, whichever is lowest. If oil particles (e.g. lubricants, cutting fluids, glycerin, etc.) are present, use a NIOSH type R or P filter. For emergencies or instances where the exposure levels are not known, use a full-face-piece positive-pressure, air-supplied respirator.
Skin Protection: Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
9. Physical and Chemical Properties
Appearance: It is white deliquescent pellets.
Odor: Odorless.
Solubility: Slightly soluble.
pH: No information found.
% Volatile by volume @ 21C (70F): -
10. Stability and Reactivity
Stability: It readily absorbs carbon dioxide from air to form calcium carbonate.
Hazardous Decomposition Products: Caustic fumes of calcium oxide form when heated to decomposition (580C; 1076F).
Hazardous Polymerization: Will not occur.
Incompatibilities: Violent reactions with maleic anhydride, nitro ethane, nitro methane, nitro paraffin, nitro propane, phosphorus. As a strongly alkaline material, it is incompatible with acids. Forms phosgene upon reaction with trichloroethylene or chloroform.
11. Toxicological Information
For Calcium Hydroxide and Sodium Hydroxide: No LD50/LC50 information found relating to normal routes of occupational exposure. Investigated as a mutagen. For potassium hydroxide: Oral rat LD50: 273 mg/kg.
Carcinogenic Effects: Not a reported carcinogen by IARC NTP ACGIH OSHA.
12. Ecological Information
Environmental Fate: Soda Lime is not expected to significantly bio accumulate.
Environmental Toxicity: No information found.
13. Disposal Considerations
Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements.
14. Transport Information
Land (DOT USA & ADR/RID)
Proper Shipping Name: SODA LIME
Hazard Class: 8
UN/NA: UN1907
Packing Group: III
International (Water, I.M.O.)
Proper Shipping Name: SODA LIME
Hazard Class: 8
UN/NA: UN1907
Packing Group: III
International (Air, I.C.A.O.)
Proper Shipping Name: SODA LIME
Hazard Class: 8
UN/NA: UN1907
Packing Group: III
15. Regulatory Information
USA:
Chemical Weapons Convention: No; TSCA 12(b): No; CDTA: No
SARA 311/312: Acute: Yes; Chronic: Yes; Fire: No; Pressure: No;
Reactivity: No (Mixture / Solid)
16. Other Information
Disclaimer:
***************************
Our company provides this Soda Lime SDS information sheet contained herein in good faith but makes no
representation as to its comprehensiveness or accuracy. This Soda
Lime MSDS sheet is intended only as a guide to the appropriate precautionary handling
of the material by a properly trained person using this product.
Individuals receiving the information must exercise their independent
judgment in determining its appropriateness for a particular purpose.
***************************
Soda Lime BP USP Manufacturers:
MUBY CHEMICALS GROUP
DONGRI-CHINCHBUNDER, MUMBAI 400009, INDIA
TEL: (OFFICE)
91-22-23770100, 91-22-23726950, 91-22-23774610, 23723564.
e-mail: info@mubychem.com
